Archives Of Email Newsletters Sent From Top Brands
How to replace new paper roll on brother DK label cartridges?
Betckey
sent this email to their subscribers on December 12, 2023.
How to replace new paper roll on brother DK label cartridges?
Betckey offer compatible DK label rolls for Brother printer. Our label cartridges can be reuseable. we are asked this question frequently by our customers: how to replace new paper roll on brother DK label cartridges? We will show you how you can easily replace your Brother DK label rolls, and keep the business smooth running.
What are Brother Printer Labels?
Brother DK labels are multi-purpose label rolls dedicated for use in Brother’s QL series thermal printers. These labels are available in various sizes, from 12mm to up to 103mm wide, for assorted utility for address, mailing, shipping, barcode, and others.
Buy our Brother DK Labels at\xa0 Lower Prices!
Brother DK2205 Continuous Paper Labels [2.4″ x 100′]
The cartridge/spool holder comprises three parts:\xa0 \xa0 \xa0 \xa0 \xa0 the board,\xa0 \xa0 \xa0 \xa0 \xa0 the support tube\xa0 \xa0 \xa0 \xa0 \xa0 the sensor
(i) Basic Configuration
Sensor – It is mounted directly on the printer spool guide Support Tube – The cylindrical part which holds the label roll and allows for smooth rolling of the label roll.\xa0 Board – Also holds the label in place, and is secured by inserting it into one of the notches in the printer.\xa0
(ii) How to Change the Label Roll
1.\xa0 To replace an old/ empty roll in a cartridge, simply pry the sensor away from the roll slowly but firmly. It should just then pop out.
2.\xa0 Once the sensor is detached, the support tube and the board can be disassembled as well.
3.\xa0 Then pick up the board and see the pin position and put the support tube downward where we can have the hole. Go right over the pin just push it through.
4.\xa0 To reassemble and install a new label roll, make sure you align the slot on the board to the pin of the support tube. This will prevent the board from moving and will lock the board in place.
5.\xa0 To lock the sensor, make sure you align the gap in the support tube with the key in the sensor. This should snap in place, without gaps in between the sides of the label roll and the holder.\xa0
6. Remember, these cartridges are reusable, but not interchangeable for different sizes of labels. You can check out different sizes of Brother DK Labels at our shop.
7. You can see how the board will go into one of these slots, depending on the label size.
